Step By Step Basic Solidworks

Step By Step Basic Solidworks

hai all did you know aboout solidworks sofware,i think you know any 3D software so i will show you step by step to create nema 17 bracket design

--Open The Solidworks Software

--Click File >> New >> Part

--Click sketch and draw using rectangle or line icon if you  want trims or extends a sketch entity to be coincident or another,or deletes sketch entity click trim entities

--After the sketch finish,click feature >> Click extruded boss/base

--Congratulation the L part already to sketch again hahahaha 😁 ,click front plane then make sketch base the dimension (use centerline when you in trouble to decide center point)

--When you already have center point ,Click sketch >> Circle >> Make from centerpoint until dimension same with picture below >> Exit sketch

--Click features >> Extruded cut >> In direction menu click through all >> Click checklist

--Click front plane then make sketch base the dimension (use centerline when you in trouble to decide center point) , when you already have center point ,Click sketch >> Straight slot >> Make from centerpoint until dimension same with picture below >> Exit sketch

--Click features >> Extruded cut >> In direction menu click through all >> Click checklist

--Congratulation the hole almost already ,click sketch to sketch again hahahaha 😁 ,click top plane then make sketch base the dimension (use centerline when you in trouble to decide center point),  when you already have center point ,Click sketch >> Straight slot >> Make from centerpoint until dimension same with picture below >> Exit sketch

--Click features >> Extruded cut >> In direction menu click through all >> Click checklist

--Congratulation the bracket almost done, click features menu >> Click fillet to creates rounded >> Click on the edge s >> Click checklist

--Yeay the part have done 😎